Does Using A Fan Use A Lot Of Electricity

Thats a lot of power.

Does using a fan use a lot of electricity. However the difference in power consumption will largely depend on a few factors such as how cool the unit is set to. A typical AC fan motor uses about 500 watts when its running. This can still add up to 50 a month or 600 a year.

Therefore if you run the fan continuously for a 30-day month 720 hours you would use 360000 watt hours 720 x 500 or 360 kilowatt hours kWh. There are times though that using the fan has benefits. Power is needed to operate the fans to direct the air to power any cooling elements and for any displays or controls on the outside.

A DC fan as opposed to an AC fan running directly on the 110-volt alternating current coming out of your wall outlet is extremely efficient and commonly uses less than a third of the energy consumed by the older AC fans. Power consumption of 48 inch Crompton fan 75 watts The power consumption of a fan depends on the sweep radius of the blades the air delivery rate and the revolution per minute of the motor but to give you a ballpark figure most ceiling fans has rated power anywhere between 60 -100 watts. AC vs fan electrical power comparison chart.

Therefore the fan uses about 360 kWh per month in the ON mode. The amount of electricity used by a dehumidifier will vary depending on your devices make model and size. As you can see in the graph for similar settings an air conditioner uses a TREMENDOUS amount of electricity vs a fan.

So much so that even when the AC units fan is set to low theres very. Keeping this in consideration how much electricity does a fan use compared to air conditioning. An AC unit on Fan mode usually consumes about 150W with the fan running while the AC unit consumes 1000W when on default or Cool mode.

In fact ceiling fans on average take less than 001hour to run as we will see in this article. Experts from This Is Money say the answer to this depends on several factors - the kind of fan you have and the amount of energy it uses. The liquid then collects in a tray and the dry air is released back into the room using a fan.