How To Remove A Drill Chuck

Tap the hex key with the mallet in a clockwise direction.

How to remove a drill chuck. We always recommend using the removal tool because it is easier for you to deal with it. Part of the series. Lets get into more detail.

1 - 8 of 8 Posts. Make sure to have padding beneath the chuck to prevent it from breaking. If that doesnt work run the bolt in as tightly as possible and give the end of the bolt a mighty smack with a BFH.

Strike the key in a clockwise direction with a wooden mallet or similar object. Once you have the screw out insert the allen key in the jaws and tighten the chuck. When removing a drill chuck check with the manufacturer of the drill to find out if the.

1 Tighten the chuck around the shorter end of a hex key not supplied of 14 64mm or greater size. This will loosen the screw inside the chuck. The easiest way to remove a drill press chuck is to insert your drill chuck removal tool into the slot on the spindle above the drill chuck.

When you need to remove the chuck the key follows the shaft to push the chuck out of the bit. A drill chuck wears down with time gets rusty and dusty. In some cases the chuck removal tool is not available at your place.

Then take a hammer and tap it in until the drill chuck falls. Right above the drill chuck there should be a spindle slot where you need to insert your chosen drill chuck removal tool. If for any reason you cannot remove your chuck we suggest getting your drill to your nearest Factory service center for further.