How To Take Apart Automotive Electrical Connectors

Use the blade of a slotted screwdriver to lift the clip if you are unable to pull it up with a finger.

How to take apart automotive electrical connectors. With a gentle tug the wire usually pulls out of the connector. The tool is double-ended to fit different access angles. Lift the clip before pulling the male and female plug housings apart if your plug is so equipped.

Simultaneously pull on the wire use your teeth or something if you dont have three hands to release the metal connector pin. Then us a small flat blade to push the locking edge in the slot out while holding the external tab down. Dont try and do the whole thing from one spot.

Works on Weather Pack and other automotive electrical connectors. 800-482-9473 Mon-Fri 8am-5pm EST. Factory Fit logo is a registered trademark.

There is a section of charts with terminal and connector illustrations part numbers and notes on terminal removal. While pulling the connector 3 away from its mating connector. I just put the screw driver there and give it a twist.

By using this guide a satisfactory repair of the wiring harness and connectors in Toyota vehicles will. Pry upwards in this fashion which will take some trial and error since the needle will most likely slip many times. All other trademarks and names are the property of their respective owners.

Additionally we supply ATO fuse block terminals as well as GM connector pins. Our collection includes Metri pack electrical connectors in a variety of options including female male 1-way 3-way 4-way and 6-way. There are some that.