How To Straighten A Bent Disc Brake Rotor

Either by sending the disc by post or dropping it down to us for a same day turn around.
How to straighten a bent disc brake rotor. OK down to the dealer and pick up a pair of discs also you might as well do a brake fluid change some would change the pads as well for a fresh start. Tighten and youre done. Rotate this section of the rotor out of the caliper.
This method works but in my opinion only on better models of hydraulic disc brakes. Brake discs can be re-trued the preferred way is to bring them to the workshop bolted onto the wheel but if you prefer discs can be sent seperately by post. Motorcycle Brake Disc Straightening.
Its a very slight bent yet it really annoyz me during training rides Im getting ready for my very first 100km marathon still a novice and is touching the brake pads makes bad sounds. A disc brake rotor tool or if you dont want to shell out the coin for this specialty tool an. Always begin with a small amount of effort on the tool and then apply more effort if no improvement is seen.
Doddy is here to let you know how to stop that irritating noise when your brakes are rubbing. 1 Mechanical knockbump. Marking where the rotor is most untrue Rotate the wheel so the too close spot comes away from the brake cylinder and pads.
Most of the time rotors bend toward the hub and you can brace the rotor with the palm of both gloved hands while pulling with your fingers against the bent portion to pull it back. Ggbb ava good day. Once we receive the discs they are then accessed and trued to a high.
We show you how to straighten a bent disc brake rotor. Spin the wheel and sight the rotor. I have straightened brake rotors several times with no problems.



















